Skip to main content

Setting up a Prattley autodrafter – Step 1 - Connecting the Tru-Test 5000 indicator to the PAD6 control unit via Bluetooth

Follow these steps to set up your Prattley autodrafter for the first time. You should only need to do this once.

Updated yesterday

This article applies to Prattley series 600 autodrafters:

  • 3-Way Swing Gate AutoDrafter

  • 5-Way Swing Gate AutoDrafter

  • 2-Way Electric AutoDrafter

  • 3-Way Slide Gate AutoDrafter

  • 3-Way Electric AutoDrafter

These autodrafters include a PAD6 control unit and a 5000 indicator (JR5000, ID5000 or XR5000).

Setting up a Prattley autodrafter is a three step process. The first step is to establish a Bluetooth® connection between the 5000 indicator and the PAD6 control unit:

Step 1 - Establishing a Bluetooth connection between the 5000 indicator and the PAD6 control unit

This step only needs to be done once.

Subsequent pairing

Once paired, then subsequent pairings should be automatic once you’ve turned the two units on.

To confirm successful connection on subsequent sessions simply:

  • Check to see the Bluetooth icon appears in the top left of the indicator screen.

  • The SCALES light is lit on the PAD6 control unit under STATUS.

Establishing a Bluetooth connection

To perform the one off procedure to establish the connection:

  1. Turn ON the indicator (by pressing the indicator On button) and display the Home screen:​

    If the Bluetooth icon appears in top left of the screen you can jump to step 4. Otherwise, you need to proceed with the following steps 2 and 3.

  2. Press Settings > Next page > Connections > Bluetooth to display a list of detected Bluetooth enabled devices.

  3. Turn Bluetooth ON and enable Auto Connect:


    📝 The indicator runs an Auto connect procedure to detect nearby Bluetooth devices, and that initially the PAD6 control unit is not listed (as it’s not switched on yet).
    ​

  4. Plug in the power to the PAD6 control unit and the red lights flicker and then settle down to its default locked keypad state.

  5. To unlock the keypad, double-tap the AUTO SETUP button repeatedly until the KEYLOCK light turns off.
    ​
    💡 Once unlocked, work quickly or the keypad will automatically lock again.

  6. Hold down the AUTO SETUP button until the MODE lights start blinking. This indicates that the PAD6 is in pairing mode, searching for nearby devices.
    ​

    After a few seconds, the Home screen on the indicator will display a Bluetooth connected symbol and the PAD6 will have the SCALES light illuminated to indicate that the two units are paired:

5000 weigh scale indicator - paired

PAD6 control unit - paired

The PAD6 control unit and indicator are now paired up and ready to operate on your next drafting session.

Next steps:

Did this answer your question?